Description

250 Mosfet Amplifier Module EBB250

This amplifier offers a highly versatile and easy to mount module

It comes supplied with a full data sheet including circuit diagram,

power supply details and constructional hints and tips.

Comes fully assembled with heat-sink bracket

These modules are ideally suited to Disco, PA and Instrument amplifiers and offer

high reliability and good sound quality. We have installed these in many bass amplifiers with great results.

Specification:

DC supply voltage Vs: ± 50 to ± 80 Volt

Output power (1KHz continuous sine Vs= ±80V): 252W RMS (504W pk) into 8 ohms

380W RMS (760W pk) into 4 ohms

Input impedance: 50K

Bandwidth: -3dB @ 7.5Hz to 42KHz

Total harmonic distortion: < 0.01% @ 1W 1KHz Input Sensitivity: 1.00V (2.82V pk-pk) @2425W Signal to noise ratio: > 42dB

Output slew rate: 22V/uS

Dimensions: 102 x 120 x 42 mm including bracket (W x L x H)

Note:

The module bracket serves as a convenient method of mounting the amplifier and eliminates the hassle of insulating the mosfets however an external heat-sink is still required with the module

Two modules will be required for stereo amplifiers

 

PLEASE NOTE

Parts are to be fitted by QUALIFIED TECHNICIANS only

There may be Hazardous voltages present and all relevant safety precautions

MUST be observed when handling and fitting

If you require assistance please contact [email protected]

Parts are non-refundable and cannot be exchanged when fitted by third party

Your statutory rights are not affected