£67.20 Inc Tax

Out of stock

SKU: EBB500 Category:

Can't find what you're looking for?
Contact Us for help.


EBB 500 Mosfet Amplifier Module

This amplifier is exclusively designed and produced for us

It offers a highly versatile and easy to mount module

It comes supplied with a full data sheet including circuit diagram,

power supply details and constructional hints and tips.

Comes fully assembled with heat-sink bracket

These modules are ideally suited to Disco, PA and Instrument amplifiers and offer

high reliability and good sound quality


DC supply voltage Vs: ± 60 to ± 90 Volt

Output power (1KHz continuous sine Vs= ±90V): 496W RMS (992W pk) into 8 ohms

740W RMS (1480W pk) into 4 ohms

Input impedance: 50K

Bandwidth: -3dB @ 10Hz to 40KHz

Total harmonic distortion: < 0.01% @ 1W 1KHz

Input Sensitivity: 1.00V (2.82V pk-pk) @496W

Signal to noise ratio: > 98dB

Output slew rate: 20V/uS

Dimensions: 200 x 110 x 40 mm including bracket (W x L x H)



The module bracket serves as a convenient method of mounting the amplifier and eliminates the hassle of insulating the mosfets however an external heat-sink is still required with the module

Two modules will be required for stereo amplifiers



Parts are non-refundable and cannot be exchanged when fitted by third party

Your statutory rights are not affected


Parts are to be fitted by QUALIFIED TECHNICIANS only

There may be Hazardous voltages present and all relevant safety precautions

MUST be observed when handling and fitting


If you require assistance please contact [email protected]